Name: Heating Thermostat
Z-Wave Certification Number:ZC10-18046084
Role Type:Always On Slave
Short Description:MCOHome Water / Electrical Heating Thermostat MH7H is a Z-Wave Plus enabled device for indoor temperature control.
Description: MH7H-WH is mainly applied to control wall mounted boiler, water valve/pump etc. , while MH7H-EH is for electrical heating system.The device is of high reliability and practicability, which can be included and operated in any Z-Wave network with other Z-Wave certified devices from any other manufacturers. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
Capacitive touch buttons
Tempered glass panel, PC alloy enclosure
Precise temperature calibration function
Clear display, easy to operate
Power Supply：AC85-260V, 50/60HZ
Output: MH7H-WH ≤5A ; MH7H-EH≤ 16A
External Temp. Sensor(optional): NTC R25℃=15KΩ
Working Environment：0-50℃; 0-90% RH（Non-
Temperature Setting：5-37 ℃（41-99℉）（Adjustable）
Association Group Info
Firmware Update Meta-Data V4
Manufacturer Specific V2
Sensor Multilevel V5
Thermostat Mode V2
Thermostat Operating State
Thermostat Setpoint V2
Transport Service V2
Z-Wave Plus Info V2
In normal working interface, press & hold S4 to enter interface for adding or removing of Z-Wave network. Before device added into network, “- - -” will display on the screen. Then press S4 once, device will enter learning mode to get a node ID. If adding is succeed, a node ID will display on the screen in a few seconds.
A node ID can always inform us whether the device is in the network or not.
After adding, turn off the device and then turn it on. Now the device is ready to be operated by controller/ gateway in Z-Wave network.
In normal working interface, press & hold S4 to enter interface for adding or removing of Z-Wave network. Before device removed from network, a Node ID will display on the screen. Then press S4 once. If removing is succeed, “- - -”will display on the screen in a few seconds.
A node ID can always inform us whether the device is in the network or not.When removed, the device will restore its factory setting.
A parameter P18 in the secret menu can be used to restore factory setting locally. Please use this procedure only when the network primary controller is missing or otherwise inoperable. ; And a parameter FF can be used to restore the factory setting via Z-Wave.
Thermostat HVAC Systems Supported
Indicate which HVAC system or systems are supported by the thermostat.
Select the mode(s) supported by the thermostat.
Thermostat Power Source
Select one or more supported power sources for a thermostat.
Indicates whether the firmware can be updated and whether it is done by the consumer or a technician.
Switch Load Capacity Current
The amount of switch load energy the product is rated for in Amps
Neutral Wire Required
For electric in-wall/wired switches, indicate whether a neutral wire is required for installation.
Sensor types supported by the product.