The KNX extension module for Zipabox is a simple integration solution for KNX protocol
It is a small "daughter" board that allows you to connect a serial interface to wireless networks based on Z-Wave
This micro USB to Ethernet adapter will allow the ZipaTile home automation controller to be connected, via an Ethernet cable, to the IP network of the home or office.
The modem 4G key allows you to always communicate with your home automation gateway when your internet connexion isn't working.
Interface with two potential-free inputs to control the devices that use the io-homecontrol radio system. They are very useful for applying agnostic home automation to IO-homecontrol to be able to manage Velux roof windows or Somfy awnings, among others, from the mobile.
Connect the HubPowerbank to your Home Center 3 Lite or Yubii Home and you will be safer than ever. A small device with wide possibilities. Up to 12 hours of emergency power battery saving mode 4600mAh capacity WiFi router Extension Manual control
The RFPlayer radio interface connects all your wireless home automation devices that work with Somfy RTS, Delta Dore X2D, Visonic, Chacon / DiO, ...
This interface will allow to considerably increase the RF emission and reception capacities (radio frequency) of the home automation installation in which it is installed. It connects through a USB port of your PC, Mac or Linux computer and also directly connected via USB to some domotic control units
Interface designed for easy installation in Nice control units. Allows easy integration with the FIBARO system.
The Remotec ZXT-600 is a Z-Wave to IR bridge that uses Z-Wave Plus technology to control air conditioners.
Z-UNO development board from the manufacturer Z-Wave.ME to unite the wireless world Z-Wave and that of Arduino to make your own Z-Wave devices. Version 2, with Z-Wave Plus technology 700 Series