The simplest remote control system on the market

Electrical plug-in format device that allows remote or local control of loads via GSM.
The load can have a maximum power of 16A.

Control your heating via mobile phone with a simple SMS!

Control your heating with your mobile phone, whether you're controlling your gas or oil boiler, electric radiators, or appliances (refrigerators, cooling units, etc.) . Turn your boiler or other system on and off with a simple SMS . It allows control of boilers and appliances that consume less than 3600W. For indoor installation, compatible with standard Schuko and European plugs. Remotely control your heating via SMS from any mobile phone.

The GSM plug is a remotely controllable plug (teleswitch) that incorporates a 2G GSM module. It allows remote control not only of a single device, but also of power strips and equipment connected in parallel.
If desired, you can use a 12-hour time-limit switch-on scheduling function. This 12-hour time-limit switch-on is very useful for controlling equipment such as heating systems to prevent accidentally leaving them on.

This smart plug is connected for remote control via SMS messages. It's a very simple and practical remote switch. Simply plug the device into a standard Schuko socket (the kind with a ground connection) and connect the appliance, boiler, or electrical device you wish to control remotely. You will interact with this remote plug by controlling it via SMS messages. The plug sends any status changes to pre-configured phones. Authorized users can send on/off commands via SMS messages from their mobile phones.

Easy-to-use GSM remote control of heating boilers : simply plug it into a power outlet and plug the appliance you wish to control into the device.

Suitable for remote control of household appliances that consume less than approximately 3600W (16 Amps AC resistive).
Equipment for indoor installation, compatible with standard CEE7/4 Schuko plugs and European variants.
It allows for a 12-hour programmed shut-off to prevent the boiler from being left on unnecessarily. A SIM card is required ( not included ). We recommend prepaid SIM cards. No data plan is required.

It is not essential to have a state-of-the-art smartphone to use it, but if you do have a smartphone, there are FREE APPLICATIONS available in your marketplace for ANDROID or iPhone for controlling SMS mobile messages, to facilitate use by managing predefined SMS messages.

Characteristics

The Chuco GSM Caldera controller is a telephone line system A mobile device that allows you to control equipment remotely via an electrical contact. Its most notable features are:

• Easy to use: simply plug it into a power outlet and connect the device you wish to control to it.
• 16A internal contact .
• Local control via push button.
• SMS control. Allows for 12-hour time-limited activation, continuous activation, and automatic deactivation. The 12-hour time-limited activation is very useful for controlling equipment such as heaters to prevent accidentally leaving the system on.
• Always sends an SMS status message back to the sender.
• The control SMS message has a password to prevent third parties from controlling it.
• No initial setup required.
• It incorporates an internal GSM antenna.
• It allows you to know the operator's signal level remotely.
• The state is memorized after 10 seconds, so that even if the power goes out, when it returns it remains in the selected state.

Description of Functioning

• The status indicator can be in three possible colors: Green indicating permanent on, red indicating permanent off, and yellow indicating on with a 12-hour limit.
• The GSM indicator has the following behavior: A rapid blink indicates that it is not connected to GSM, and if it is a rapid blink like a flash, it indicates that it is connected to the GSM network.
• The push button allows manual control of the status and password reset.

Technical specifications

Power supply: 230V~50Hz
Maximum current: 16A
Operating temperature: -5ºC to 50ºC (Non-condensing)

Maximum humidity: 60% (Avoid condensation)
GSM Band: EGSM900, DCS1800

CHARACTERISTICS:

GSM plug for remote on/off control via SMS messages (traditional mobile phone messages)

With external temperature sensor operating -10°C to +50°C
Notifies via SMS in case of power failure
Automation is possible based on temperature or schedule
Up to 5 registered users

Among other applications, it allows for mobile heating control.

Turn heating on/off remotely in second homes
Turn on the sprinkler according to the temperature or the schedule
Restarting a server, a transmitter, a router, etc...
iOS and Android apps available

TECHNICAL CHARACTERISTICS:

Power input: 240VAC
Output voltage: 240V AC regulated
Current output: 16A max
Maximum connected power: 3500 W
Communication: 4 GSM bands
SIM card connection: 1 port/slot: has a socket for inserting a standard SIM card
Settings / Control: SMS - App for Android and iOS
ON/OFF control: SMS, call and automatic functions such as temperature and calendar
Planning: YES

GSM antenna: Integrated
Security: Limiting the list of numbers authorized by the main user
Number of users: 5 Maximum
planned temperature sensor
Number of linked slave sockets (main socket): maximum 4
SIM format required: Standard / Mini SIM
Compatible with any mobile phone operator

It features automatic temperature-based operation, allowing control of certain electrical appliances, such as heating or cooling systems. It can be programmed to operate within specific temperature ranges.

It features a call-saving function that changes the ON/OFF state of the plug when it receives a call from an authorized user. The plug identifies the call, changes its state, and hangs up to avoid charges: state changes via missed calls.

Automatically synchronizes the time

Technical characteristics of the GSM boiler controller

Size: 125 × 60 × 80mm
GSM frequency 850/900/1800/1900MHz
AC110 ~ 230V power supply
Maximum charging power 16A or 3600W
Temperature: range -10°C ~ +50°C
Blue LED power and network indicator

Type of SIM required: MINI SIM