Valor por defeito
Watt Meter Report Period
If the setting is configured for 1hour (set value =720), the Switch will report its instant power consumption every 1 hour to Group1 node. The maximum interval to report its instant power consumption is 45 hours (5s*32767/3600=45hr). When the setting is set at 0, the Switch will disable Watt auto report function. The default value is 720.
Manual Switch Report Mode
The default setting is Enable the function. Whenever the Switch is manually switched on or off, it will send BINARY_SWITCH_REPORT to the node of group1.
Auto Report after Reset
Whenever the Switch is repowered, it will check this parameter for if sending a BINARY_SWITCH_ REPORT to the node of group1 or not. The default setting is Disable the function.
The overload current can be adjustable from 4.5A to 14.5A. The default value is 1450 for 14.5A. (1450 * 0.01A = 14.5A).
KWH Meter Report Period
If the setting is configured for 1hour (set value =6), the Switch will report its Accumulated Power Consumption (KW/h) every 1 hour to Group1 node. The maximum interval to report its Accumulated Power Consumption (KW/h) is 227.55 days (10min*32767/1440=227.55 days). When the setting is set at 0, the Switch will disable KWH auto report function. The default value is 6.
Threshold of current for Load caution
This is a warning when the current of load over the preset threshold value, if the setting value is 1300, when the load current of Relay1 over this value, Swtich will send current meter report to warn the Group1 node, the Range of the setting value is from 10 to 1300,and the default value is 1300.
Threshold of KWh for Load caution
This is a warning when the KWh of load over the preset threshold value, If the setting value is 10000, when the Accumulated Power Consumption of Relay1 over this value, the Switch will send KWH meter report to warn the Group1 node, minimum value is 1KWh and default value is 10000 kWh.
Restore switch state mode
Whenever the AC power return from lost, the Switch will restore the switch state which could be SWITCH OFF, LAST SWITCH STATE, SWITCH ON. The default setting is LAST SWITCH STATE.
Mode of Switch Off function
When the mode of switch On/Off is set to 0, any command of switch off will be disabled and the On/Off function of include button will be disabled. The default setting is enable mode. When manual On/Off function is disabled, the RF command can only switch On but not Off. This is useful function for keeping the device in switch on state.
LED indication mode
1.SHOW SWITCH STATE:
When the Switch is on, LED is on. When the Switch is off, LED is off. The default setting is Show Switch State.
2.SHOW NIGHT MODE:
When the Switch is on, LED is off. When the Switch is off, LED is on.
3.ONE FLASH MODE:
When the state of the Switch changes, LED will turn on for 1 second.
Auto off timer
Whenever the Switch switches to on, the auto off timer begin to count down. After the timer decrease to zero, it will switch to off automatically. However if Auto off timer is set as 0, the auto off function will be disabled.
RF off command mode
Whenever a switch off command, BASIC_SET, BINARY_SWITCH_SET, SWITCH_ALL_OFF, is received, it could be interpreted as 4 variety of commands. The default setting is Switch Off.
It switches to OFF state. The default setting is Switch Off.
The switch off command will be ignored.
It switches to the inverse of current state.
It switches to ON state.