Nome: Siren Gen5
Número de Certificação Z-Wave :ZC10-14090013
Plataforma de Hardware :ZM5202
Tipo de Role :Always On Slave
Descrição breve :Siren Gen5 is a siren Z-Wave device that when an emergency is happening it lets you know.
Descrição :Aeon Labs Siren Gen5 is a siren Z-Wave device that when an emergency is happening it lets you know. Its 105dB Speaker System is always heard. Its super-bright LED system lights your path even when it’s dark. Siren provides a smart home with the perfect security and safety features that it needs.
Those security and safety features are matched by smart features. Siren’s speaker system can access 5 different audio alerts, allowing your smart home to pick the alert best suited to the emergency. The speaker system’s volume can also be adjusted so that Siren is perfect for every space in every home.
It also act as a repeater that forward Z-Wave command messages to destination nodes if the originating controller is out of range from the destination node.
By taking advantage of the Z-Wave mesh network, commands can be routed to their destination via intermediary “listening” Z-Wave products. Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices.
Also a tool that can be programmed, scheduled, controlled and communicated with from anywhere in the world.
Descarregue o manual a partir de aqui.
Group 1 is assigned to the Lifeline association group and every device has 5 nodes to associate.
When the Siren is received the commands sent by controller to be turned on or off, the Siren will send a basic report of its status to the nodes in association group 1. To change what kind of signal is sent to the nodes in group 1, please see the detailed description of configuration parameter 80.
Valor por defeito
This parameter is used to configure the partner ID.
(0== Aeon Labs Standard Product, 1~255== others).
Enable/Disable Lock Configuration
This parameter is used to enable/disable Lock all configuration parameters.
(0 =disable, 1 = enable)
Reset to default factory setting
This parameter is used to reset product to default factory setting. (There are just 2 values can be used).
Configure the Siren sound and its volume
This parameter is used to configure the sIren sound and volume as the default setting.
Enable/Disable to send notifications to associated devices to associated devices.
This parameter is used to Enable/Disable to send notifications to associated devices (in Group 1) when the state of Siren Gen5’s load is changed.
(0=Send nothing, 1=Send hail CC, 2=Send basic report CC).
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action button that you can find on the product's housing.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action button that you can find on the product's housing.
Learn Mode (adding another controller)
Press and hold the Action button that you can find on the product's housing for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable.
Additional Special Features
Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.