The Vision Security ZF5201 flood...
The Vision Security ZF5201 flood detector or sensor monitors for leaks and floods and sends a Z-Wave signal when it detects water in the ground .
Warning: Last items in stock!
|Technology||Z-Wave (Comp. con Z-Wave)|
The flood sensor FOR SAFETY APPLICATION AND TECHNICAL ALARMS with Z-Wave VISION ZF5201 technology monitors for leaks and sends a Z-Wave signal when a flood or leak is detected. The detection device can be placed up to 2 m from the main unit with its cable. The device can be mounted on any flat surface. The installation can be carried out with screws or double-sided tape.
Powered by battery, the detector remains in standby mode most of the time, and wakes up only when an action is detected. It can be configured so that the sensor sends information about its status. Then it returns to the standby mode.
The sensor sends information to the Z-Wave controller when the battery needs to be replaced. This sensor also has an anti-tamper contact that sends an alarm to the controller when the "tamper" is activated.
A Z-Wave controller (domotic control dongle, home automation control unit, ...) is necessary to integrate the detector into your Z-Wave network.
Z-Wave wireless flood sensor
Protect your home from floods
Button to include / exclude the detector
Supports an association group (up to 5 devices)
Protection against interventions
Use the Z-Wave SDK 6.51.00
Ease of use and installation
TECHNICAL CHARACTERISTICS :
Type of device Z-Wave: Slave
Power supply: 1 lithium battery CR123A 3V
Frequency: 868.42 MHz
Z-Wave transmission distance: 30m in optimal conditions
Operating temperature: -15 to 60 ° C
Dimensions: 87 x 25 x 21 mm